USB 3.0 PCI-E Express 1x to 16x Extender Riser Card Adapter SATA Power Cable
Safer, more efficient, more practical
The graphics card power supply adopts three FP solid-state capacitors, make graphics more stable power supply security.
Parallel transfer tapes or big 4 pin interface to strengthen the power supply and make the video card power independence from motherboard
Solve the problem that welding point fragile burn, transmission signal attenuation, platoon line length is not enough and so on
Slots with fixed card buckle, remove the graphics card and the fixed graphics, the graphics card will not fall off from the slot
1. Power Connector: Sata 15 pin power cable
2. The board size: 129mm * 43mm
3. USB Cable Length: 300mm
4. Compatible use: With any graphics cards
1. This extension is applicable to the mainboard PCI – E slot (1 x 2 x, 4 x 8 x 16 x). Please plug in the power cord for the floppy. When plug PCI – E extension must be computer broken wires plug again.
2. The form a complete set of wire rod is customized, never grab line to plug in. Remember that!
3. When plug wire must identify the direction, not to counter or offset, prevent burning equipment, plug wire when the socket of equipment first, then plug wire, avoid too hard plug socket pin is broken.
4. Big 4 pin for power supply standard parts, please check put in place, when inserted into the power supply plug line must be careful.
5. Dual-core graphics Suggestions with the old line, the mainboard is 16 x also recommends using the old row line!
1 x PCI-E 16X adapter
1 x PCI-E 1X riser board
1 x USB3.0 cable
1 x SATA15Pin-4Pin Power cable
1x PCI-E 16X adapter
1x PCI-E 1X riser board
1x USB3.0 cable
1x SATA15Pin-4Pin Power cable