This exhaust system sealer used for leaks in mufflers, tailpipes and around joints. Saves the cost of expensive muffler system replacement. Also makes new installation more secure. Sets like a weld, remarkable adhesion to clean or rusted surfaces. Resistant to monoxide gases and high temperatures.
1. Save energy
2. Applies easily
3. Stop air leak
4. Sets rock hard when heated
5. Super tough, high temperature mortar
High temp up to 2012℉ (1100℃)
1.Clean all grease, dust on the surface of the exhaust pipe
2.Smear the exhaust pipe glue to the surface of the area to be repaired Evenly.
3.Curing under room temperature for at least 24 hours (if the gap\'s range is exceed 0.5cm, it must be used with wire mesh)
4.Heat cure for 15 minutes (if the surface is blistered, it should be scraped off and re-bonded)
1.be sure to mix well before use
2.Before use, clean the surface of the exhaust pipe to be repaired, such as rust, grease and so on
3.This product should be stored in a cool, ventilated, dry and sealed environment with a shelf life of 12~15 months
4.The product can be cured at normal temperature, and can be heated and cured
1. There may be slight size deviations due to manual measurement, different measuring methods and tools.
2. The picture may not reflect the actual color of the item because of different photographing light, angle and display monitor.
1 X Exhaust Pipe Sealant