1. For Intel AX200:
Adopt Intel\\\'s sixth-generation wireless protocol AX standard. Compared with the previous generation 802.11AC protocol, enhanced performance, improved compatibility while reducing power consumption and increasing service life.
MU-MIMO (multi-user MMO) technology, with the MU-MNO router, enjoys exclusive high bandwidth, does not interfere with each other, and has high efficiency and speed.
3. Dual Frequency Freely:
Using 802.11ax wireless transmission standard, the transmission rate is up to 2974M 2.4G 574M+5.8G 2400M (The router needs to support AX and needs to use 160MHz broadband to reach 2400Mbps)
4. Bluetooth 5.0 Stable and High Speed:
A new generation of Bluetooth 5.0 chip, lower power consumption, more stable and easy control for game and entertainment.
5. Simulate AP launch:
Support analog AP function, different wireless router AP can also build WiFi, notebook, for iPad, mobile phone can easily play wireless.
1. High Gain Antenna:
High-purity oxygen-free copper antenna to enhance the wireless signal strength of the network card and increase the receiving and transmitting distance.
2. Gold-Plated Antenna Connector:
The gold-plated antenna connector has better contact and more stable signal transmission and receiver.
3. Thicken Golden Finger Interface:
Adopting gold-plated technology to thicken the gold-plated gold finger, which has better contact with the motherboard PC-E slot, which is convenient for data transmission and can effectively reduce the packet loss rate.
4. Lossless Feeder:
The main control and SAM interface adopts a direct connection method to effectively reduce attenuation and enhance signal stability.
Bus Interface: PCI-E X1 (Compatible With X4X8X16)
Transmission Rate: 2.4GHz: 574Mbps 5GHz: 2400Mbps
Protocol Standard: Support IEEE802.11ax; Support IEEE802.11ac
Protocol Standard: Support IEE802.11a/b/g/n
Technical Support: MU-MIMO
Wireless Frequency Band: 2.412GHz-2.4835GHz 5.150GHz-5.825GHz
Transmit Power: 20dBM
Encryption Mechanism: WPA-PSK/PWA2-PSK/ WPA/WPA2/WEP
Support System: Win10 (64 Bit)
Support Chassis: Support Full Height/Half Height
Product Size: 120 X 77 X 18mm/4.72 X 3.03 X 0.71\\\"
1. Open the Chassis: Unscrew the PC case screws and open the side cover.
2. Remove the baffle: Remove the baffle corresponding to the slot where the PC|-E card is to be inserted.
3. Insert the riser card: Insert the product into the corresponding card slot. PCI-E/X1/X4/X8/X16 are supported. (It is forbidden to insert the PCI card slot).
4. Connect to the network card: Connect the wireless network card with the 4-pin port of the Bluetooth cable.
5. Connect to the motherboard: Connect the motherboard 9-pin USB with the 9-pin port of the Bluetooth cable.
6. Fix the Network Card: Fix the network card to the chassis with screws.
7. Installation is Complete: Finally screw the antenna to the network card.
1. Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
2. Please allow 1-3mm measuring deviation due to manual measurement.
1 X AX200 Wireless PCI-E Adapter
1 X Bluetooth Cable
1 X Low Bracket
2 X High Gain Antennas
1 X CD
1 X Screwdriver
2 X Screws