Working voltage: DC 6V
Working current: 14mA
Quiescent current: 0mA
Working frequency: 315MHz, 433MHz (optional)
Transmitting power: 10mW
Transmitting distance: 100m (open environment)
Product size: 67*35*12mm/2.64*1.38*0.47\\\"
Application: duplication and regeneration of wireless remote controls such as barriers, garage doors, cars/motorcycles, etc.
Applicable remote control: ordinary fixed code (chip type 2260, 2262, 2264), learning code (1527, 2240) remote control.
1. Code pairing (learning)
Place the original remote control and the copy remote control as close as possible, first press a button of the original remote control, and immediately after the indicator light turns on, press and hold a button of the copy remote control for about 3 seconds, the LED will flash 3 times and then quickly flash, it means that the address code of the original remote control button has been learned successfully. The other keys are operated in the same way for learning.
2. Clear code
Press the unlock button and the lock button at the same time for 2 seconds, and the LED light starts to flash 3 times. At this time, keep the lock button pressed and release the unlock button. Press the unlock button three or four times within 5 seconds, and the indicator light flashes quickly. The code has been cleared.
Test whether the existing code of the remote control has been successfully cleared: When you finish the clearing action, you can press any button of the copy remote control. If the LED does not flash immediately at this time, it will flash after 2 seconds, that means The original code of the copied remote control has been completely cleared. If the LED still flashes quickly and immediately, the code still exists and needs to be cleared again.
3. Recover the cleared code
The copy remote control has a recovery function. If you accidentally clear the address code of the normal copy remote control during use, you can press the start and mute keys (the next two keys) on the remote control at the same time. After about three seconds, the LED will flash 3 times. It starts to flash quickly, which means that the cleared address code is successfully restored.
1. Before using our copy remote control, first clear the existing code of our copy remote control.
2. Our copy remote control cannot copy rolling code, such as HCS301.
1. There may be slight size deviations due to manual measurement, different measuring methods and tools.
2. The picture may not reflect the actual color of the item because of different photographing light, angle and display monitor.
1 X Remote Control Duplicator